Need Help Please for Satin Lacy Throw to Knit

[anna]

Pattern is as follows:
INSTRUCTIONS
Lace Panel (worked over 9 sts).
1st row: (RS). K1. yo. K1. K2tog. P1. Sl1. K1. psso. K1. yo. K1.
2nd and alt rows: P4. K1. P4.
3rd row: As 1st row.
5th row: K2. K2tog. yo. P1. yo. Sl1. K1. psso. K2.
7th row: K1. K2tog. yo. K1. P1. K1. yo. Sl1. K1. psso. K1.
9th row: K2tog. yo. K2. P1. K2. yo. Sl1. K1. psso.
10th row: As 2nd row.
These 10 rows form Lace Panel Pat.
Cast on 180 sts. Do not join. Knit 7 rows (garter st), noting first row is WS and inc 19 sts evenly across last row. 199 sts.
1st row: (RS). *P2. Work 1st row Lace Panel. (P2. K2tog. yo. P2. yo. Sl1. K1. psso) twice. P2. K2tog. yo. Rep from * to last 13 sts. P2. Work 1st row Lace Panel. P2.
2nd row: *K2. Work 2nd row Lace Panel. (K2. P2) 5 times. Rep from * to last 13 sts. K2. Work 2nd row Lace Panel. K2.
3rd row: *P2. Work 3rd row Lace Panel. (P2. yo. Sl1. K1. psso. P2. K2tog. yo) twice. P2. yo. Sl1. K1. psso. Rep from * to last 13 sts. P2. Work 3rd row Lace Panel. P2.
4th row: As 2nd row.
Last 4 rows form pat. Lace Panel Pat is now in position.
Cont in pat until approx 54½ ins [138.5 cm] total length ending on a 4th row of Lace Panel Pat.
Next row: (RS). Knit, dec 19 sts evenly across. 180 sts.
Knit 6 rows. Cast off knitwise (WS).
Side edging: (RS). Pick up and knit 226 sts across side edge. Knit 6 rows. Cast off knitwise (WS). Rep along opposite side.


I started by casting on 180 sts and worked the 7 rows of garter stitch. Now I'm confused, as there are 2 sets of instructions for lace panel.

Please Help!!
Thanks,
Anna

[LuckyRainbow]

You should work the directions between the "*" over and over until you only have 13 stitches left on your needle, then work the directions at the end. So, it is a 31 stitch repeat followed by 13 stitches. Which ends up being 7 lacy panels with filler stitches between them.

Also, make sure you did the 19 stitch increase on your last row of garter stitches.

I hope this helps. I often have the same problem.